HP ProLiant ML350p Gen8 Server - Manual (Page 77)

Hardware options installation 77
o For tower models, install the bezel.
o For rack models, if removed, install the security bezel (on page 21 ).
Graphic card option
The server supports up to three graphic card options. The server supports up to two double-wide graphic
cards.
For optimal performance, HP recommends that you install graphic card options in PCI slots 3, 6, or 8.
HP recommends the following:
• If the graphic card is populated in PCI slot 3, do not use PCI slot 2.
• If a single-wide graphic card is populated in PCI slot 8, do not use PCI slot 9.
• In a single-processor configuration, HP recommends installing the graphic card in PCI slot 3.
• In a two-processor configuration, HP recommends installing the graphic card in PCI slot 6.
• If a third graphic card is installed, HP recommends installing the third graphic card in PCI slot 8.
Installing a graphic card adapter option
1. Do one of the following:
o For tower models, open and remove the bezel (" Remove the tower bezel " on page 21 ).
o For rack models, if installed, remove the security bezel (on page 21 ).
2. Power down the server (on page 20 ).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 24 ).
5. Remove the access panel (on page 23 ).
6. Remove the air baffle (on page 25 ).
7. Remove the fan cage.
8. Select the appropriate PCIe slot to install the graphic card adapter.