HP MSR Encryption Accelerators - Manual (Page 41)

Utilities 41
You can specify multiple IO Accelerator devices. For example, /dev/fct1 /dev/fct2 indicates the
second and third IO Accelerator devices installed on the system. You can also use a wildcard to indicate all
IO Accelerator devices on the system.
For example, /dev/fct*
Option Description
-c Attach only if clean.
-q Quiet: disables the display of the progress bar and
percentage.
fio-beacon
Description
The fio-beacon utility enables all three LEDs on, to identify the specified IO Accelerator device.
IMPORTANT: This utility enables the LEDs on, unless you select the -0 option.
Syntax
fio-beacon <device> [options]
where <device> is the name of the device node (/dev/fctx), where x indicates the card number: 0, 1,
2, and so on. For example, /dev/fct0 indicates the first IO Accelerator device installed on the system.
Options Description
-0 Off: Turns off the three LEDs
-l On (default): Enables the three LEDs on
-p Prints the PCI bus ID of the device at <device> to standard output. Usage and error information
may be written to standard output rather than to standard error.
fio-bugreport
Description
Prepares a detailed report of the device for use in troubleshooting problems. The results are saved in the
/tmp directory in a file that indicates the date and time the utility was run.
Example
/tmp/fio-bugreport-20100121.173256-sdv9ko.tar.bz2
Syntax
fio-bugreport
NOTE: If the utility recommends that you contact Fusion-io support, disregard that message and
contact HP support ( http://www.hp.com/support ) instead.
Sample output
-bash-3.2# fio-bugreport /tmp/fio-bugreport-20090921.173256-sdv9ko ~
Collecting fio-status -a