HP MSR Encryption Accelerators User Manual
Hp io accelerator version 3.2.3 linux user guide
Advertising
HP IO Accelerator Version 3.2.3 Linux
User Guide
Abstract
This document describes software requirements for all relevant HP IO Accelerators using Linux operating systems. This document is intended for
system administrators who plan to install and use HP IO Accelerators with a Linux operating system. It is helpful to have previous experience with HP
IO Accelerators and a Linux operating system. This user guide is intended for IO Accelerator software release 3.2.3 or later.
Part Number: 647094-003
February 2013
Edition: 3
Advertising
This manual is related to the following products:
AXL300 Accelerator SSL PCI Card, Thunderbolt-2 PCIe 1-port IO Card, Storage C-series Switch Accelerators, Fusion ioFX 410GB PCIe Accelerator, Thunderbolt 2-Port AiO Module, B-series Switch Accelerators, IO Accelerator for BladeSystem c-Class, HPAtalla AXL600L SSL Accelerator Card, PCIe IO Accelerators for ProLiant Servers
Table of contents
Document Outline
- HP IO Accelerator Version 3.2.3 Linux User Guide
- Abstract
- Notice
- Contents
- About this guide
- Introduction
- Software installation
- Installation overview
- Installing RPM packages on SUSE, RHEL, and OEL
- Building the IO Accelerator driver from source
- Upgrading device firmware from VSL 1.x.x or 2.x.x to 3.x.x
- Loading the IO Accelerator driver
- Setting the IO Accelerator driver options
- Upgrading the firmware
- Enabling PCIe power
- Using the device as swap
- Using the Logical Volume Manager
- Configuring RAID
- Understanding Discard (TRIM) support
- Setting up SNMP for Linux
- Maintenance
- Utilities
- Monitoring IO Accelerator health
- Performance and tuning
- NUMA configuration
- Resources
- Regulatory information
- Support and other resources
- Acronyms and abbreviations
- Documentation feedback
- Index