HP ProLiant DL180 Server User Manual
Page 54
Using LO100 54
2.
Press the right arrow (→) key to navigate to the Advanced menu.
3.
Press the down arrow (↓) key to scroll to IPMI. Press the Enter key.
4.
To set your network BIOS settings, choose one of these options:
o
On ML110 G5 and ML150 G5 servers:
i.
Press the down arrow (↓) key to scroll to the end, and then select DHCP IP Source.
ii.
On DHCP IP Source, select Disabled.
iii.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab key to move between address fields).
o
On ML115 G5 servers:
i.
Press the down arrow (↓) key to scroll to the BMC LAN Configuration menu. Press the Enter
key.
ii.
Press the down arrow (↓) key to scroll to the end, and then select DHCP IP Source.
iii.
On DHCP IP Source, select Disabled.
iv.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab key to move between address fields).
o
On DL120 G5 servers:
i.
Press the down arrow (↓) key to scroll to the LAN Settings menu. Press the Enter key.
ii.
On IP Address Assignment, select Static.
iii.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab key to move between address fields).
o
On DL160 G5, DL165 G5, DL180 G5, and DL185 G5 servers:
i.
Press the down arrow (↓) key to scroll to the LAN Configuration menu. Press the Enter key.
ii.
On DHCP IP Source, select Disabled.
iii.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab or period (.) key to move between address fields).
5.
Press the F10 key to save and exit.
To enable a DHCP assigned address:
1.
Press the F10 key during POST to enter the BIOS Setup Utility.
2.
Press the right arrow (→) key to navigate to the Advanced menu.
3.
Press the down arrow (↓) key to scroll to IPMI. Press the Enter key.
4.
BIOS settings for SL165z G6 server are set by default. To set your network BIOS settings, choose
one of these options:
o
On ML110 G5 and ML150 G5 servers:
i.
Press the down arrow (↓) key to scroll to the end, and select DHCP IP Source.
ii.
Set DHCP IP Source to Enabled.
o
On ML115 G5 servers:
i.
Scroll to the BMC LAN Configuration menu by pressing the down arrow (↓) key. Press the
Enter key.
ii.
Press the down arrow (↓) key to scroll to the end, and select DHCP IP Source.
iii.
Set DHCP IP Source to Enabled.