HP xw4400 Workstation - Manual (Page 88)

HP Remote Graphics 4.2.0 User's Guide
80
log file. If WARN level is chosen, then all levels from WARN to FATAL will be output.
The default value is INFO - all DEBUG output is turned off.
Rgreceiver.Log.MaxFileSize=int
This sets the maximum size of the log file in kilobytes (Kbytes). The default
maximum size is 1024 Kbytes.
Rgreceiver.Log.NumBackupFiles=int
If the log file exceeds its maximum size, the log file will be saved and a new log file
will be created. This sets the number of extra files that will be saved. The default
number of saved files is five.
Networking Properties:
Rgreceiver.Network.Timeout.IsMutable=bool
I f set to "1", the user can modify all network timeout values in the RGS Receiver
Control Panel. If set to "0", the user cannot modify the values. This property can be
used to permanently set network timeouts before the RGS Receiver is started. The
default value is "1" - timeout values are changeable by the user.
Rgreceiver.Network.Timeout.Warning=int
The timeout in milliseconds used to detect and notify the user of a network
disruption. The default value is 2000 milliseconds - two seconds.
Rgreceiver.Network.Timeout.Error=int
The timeout in milliseconds used to detect and disconnect an inactive connection.
The default value is 30000 milliseconds - thirty seconds.
Rgreceiver.Network.Timeout.Dialog=int
The timeout in milliseconds used to display and wait on responses from input dialogs,
such as the
authorization dialog and PAMauthentication dialog. The default value is
15000 milliseconds - fifteen seconds.
USB Properties:
Rgreceiver.Usb.IsMutable=bool
If set to "1", the user will be able to modify all USB controls in the RGS Receiver
Control Panel. If set to "0", none of the controls can be changed by the user. This
can be used to permanently enable or disable remote USB before the RGS Receiver
is started. The default value is "1".
This property only applies to HP Blade Workstation Client.