HP Insight Management-Software - Manual (Page 25)

Table 4 MAC or WWN address and serial number range compatibility
VCEM-supported
MAC or WWN or serial number in VC
Domain Group
VC Domain server profiles with MAC
or WWN addresses or serial number
allocated as:
Yes VCEM-defined or user-defined VCEM-defined
Yes, as long as it belongs to the same
User-defined range User-defined User-defined
Yes, if a User-defined range is created
on VCEM VCEM-defined User-defined
Yes Factory, VCEM-defined or
User-defined Factory (MAC or WWN address)
Yes VCEM-defined HP-predefined
Yes, if a User-defined range is created
on VCEM User-defined HP-predefined
No Factory VCEM-Defined, HP-predefined, or
User-defined
VCEM validates the following components when adding a VC Domain to a VC Domain group,
therefore the VC Domain configuration must be identical to the VC Domain Group configuration.
Verify that the following components are identical:
•
Interconnect bays location and model
•
Enclosure model
•
Domain settings:
Configuration for double density servers (for example, BL2x220c) ◦
◦ Configuration for full-height and half-height single density servers (for example, BL460c,
BL480c)
•
Network Access Groups
◦ Name(s) and networks
•
Ethernet and iSCSI Flex-10 settings:
◦ MAC Cache Failover:
Enable Fast MAC Cache Failover –
– MAC Refresh Interval
◦ IGMP Snooping:
Enable IGMP Snooping –
– IGMP Idle Timeout Interval
◦ Server VLAN Tagging support:
Tunnel VLAN Taggings or Map VLAN Taggings –
– Force Server connection setting
◦ Multiple Network Speeding Settings:
Preferred Link Connections –
– Preferred Link Connection Speed
– Maximum Link Connection
– Maximum Link Connection Speed
Requirements for adding a VC Domain to a VC Domain Group 25