HP OneView for VMware vCenter - Manual (Page 61)

•
Host Access
P4000—Host access level assigned to the presentation of the disk to the host (for example,
READ/WRITE or READ-ONLY) ◦
◦ 3PAR—N/A. 3PAR storage volumes operate in a read-only/read-write configuration.
◦ P6000 EVA—Host access level assigned to the presentation of the disk to the host (for
example, READ/WRITE or READ-ONLY)
◦ P2000/MSA2000—Access setting for volume mapping (for example, READ/WRITE or
READ-ONLY)
◦ P9000/XP—Host access level assigned to the volume
NOTE: The P9000 or XP array does not allow host access to be specified on a per-host
or per-path basis.
•
Array Port Speed
P4000—Not applicable ◦
◦ 3PAR—Speed at which the port is connected to the SAN (Gb/s)
◦ P6000 EVA—Speed at which the port is connected to the SAN (Gb/s)
◦ P2000/MSA2000
FC—Speed at which the port is connected to the SAN (Gb/s) –
– iSCSI—Speed at which the network port is connected to the network (Gb/s)
– SAS—Speed at which the port is connected to the host or switch (Gb/s)
◦ P9000/XP—Speed at which the port is connected to the SAN (Gb/s)
•
Host Mode
P4000—Not applicable ◦
◦ 3PAR—Not applicable
◦ P6000 EVA—Host mode assigned to the P6000 EVA host object
◦ P2000/MSA2000—Name of the host's profile
◦ P9000/XP—Host mode assigned to the host group
•
Preferred Path
P4000—Not applicable ◦
◦ 3PAR—Not applicable
◦ P6000 EVA—Specifies whether the path uses a port on the controller that is configured
as the preferred path for the vdisk (Yes, No, No preference)
◦ P2000/MSA2000—Not applicable
◦ P9000/XP—Not applicable
•
Active Path—Specifies whether the path is active or in standby status
If a path is active and then goes offline, a standby path takes over.
Using the Storage Module for vCenter 61