Administrative module removal – HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem User Manual
Page 152
Hardware information screens 152
Column Description
Connected To
WWN address of the device that this port is connected to on the other end
Profile
Server Profiles with connections to this port
HBA Port
HBA port number
HBA Port Speed
Speed setting of the HBA port
HBA Port Status
Status of the HBA port
HBA WWPN
Either the World Wide Port Name assigned to the port or the Server
Factory Default, if not assigning WWNs
Administrative module removal
The Remove from Domain feature enables users to remove an interconnect module from the Virtual
Connect domain without having to delete the entire domain, or having the bay permanently configured
for a specific interconnect module type.
Removing a VC-Enet module and installing it in another enclosure causes the configuration information on
that module to be cleared. This action prevents a configured spare from overwriting configuration data in
another enclosure.
To temporarily remove the module from the domain, do not click Remove from Domain. Simply re-install it
into the enclosure.
To permanently remove the module from the Virtual Connect domain be sure the following conditions are
met:
NOTE:
The attachment of stacking link cables to a module does not prevent a Remove from
Domain action.
•
VC-Enet conditions:
o
The user must have Domain privileges.
o
The module must be physically removed from the bay.
o
The interconnect bay must remain empty for this procedure.
o
The module uplink and downlink ports cannot be in use by networks, uplink sets, or profiles
(including FC profiles) in the enclosure.
o
Port monitoring cannot be enabled on that bay.
•
VC-FC conditions:
o
The user must have Domain privileges.
o
The module must be physically removed from the bay.
o
The interconnect bay must remain empty for this procedure.
o
Change all fabrics on that module to Unassigned for all Virtual Connect profile configurations.
•
If removing an FC module from a multi-enclosure domain, all FC modules in that bay in each
enclosure must be missing. Removing one of the missing modules removes the module from all
enclosures.
If these conditions are met, click Remove from Domain.