HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 26)

Domain management 26
Task Action
screen
Clear the enclosure checkboxes Click Cancel.
Deleting a domain
CAUTION: Deleting a domain returns all settings to factory default. This action cannot be
undone.
1. Power off all servers that are associated with profiles. See "Server Bay Status screen (on page
160)."
2. Navigate to the Domain Settings (Domain Configuration) screen (on page 25).
3. Click Delete Domain. A domain name verification window is displayed.
4. Enter the name of the domain to be deleted. This should be the name of the domain you are
currently logged into, displayed in the Virtual Connect Domain Name box on the Domain Settings
(Domain Configuration) screen (on page 25).
5. Click OK.
If deleting a domain that was using MAC addresses predefined by HP, the administrator should also
update the "Teaming" driver configuration file on the host OS. Otherwise, the driver reinitializes to the
saved MAC address predefined by HP and not the factory default value.
Domain Settings (Domain IP Address) screen
Use this screen to set a domain IP address for the Virtual Connect domain.
The optional domain IP address setting allows for a consistent IP address that is independent of the
interconnect module on which it is running. If set, this IP address must be unique within the network and
must be different than the IP address of the module itself. If this IP address is not set, the VC Manager can
still be reached through the IP address of the host Virtual Connect Ethernet module.
To use an optional domain IP address, select the Use Domain IP address checkbox, and then enter the IP
Address, Subnet Mask, and Default Gateway.
NOTE: Even if a domain IP address is provided, the normal IP address assigned to the
interconnect bay can still be used.