HP 3PAR Service Processors - Manual (Page 52)

5.4 Managing Connection Portal Controls
3PAR Service Processor User’s Guide
3 Select option 6, File Transfer Monitor and press ENTER.
 To stop the File Transfer Monitor, on the transfer monitor menu, type q.
5.4 Managing Connection Portal Controls
When in SP mode, there are several functions allow for management of the Connection Portal.
To change any of these functions:
1 Log in to the SPMAINT utility.
2 From the SP Main menu, select option 2, Network Configuration.
3 Select option 2, Connection Portal Control.
The following options are displayed, with their respective values displayed along the right
column. As you edit the values displayed in this menu, the new values appear to the right
of the current values.
◆ Current Connection Portal
◆ Connection Portal Public IP
◆ Host Route to Portal
◆ Proxy Service
◆ CP Phone number(s)
◆ Dialout prefix
◆ Ignore Dialtone
◆ Restore 3PAR defaults
◆ Active Secure Network Mode (See 5.4.1 Activating Secure Network Mode on page 5.5)
4 Type S and press ENTER to save changes.
NOTE: Modifications made with this submenu are not permanent until they are
saved or activated from this menu using menu option S. The modifications are not
retained if you exit this menu without saving or activating them.