HP ProLiant BL20p G4 Server-Blade - Manual (Page 27)

Hardware options installation 27
Installing FBDIMMs
1. Power down the server blade (on page 15 ).
2. Remove the server blade (on page 16 ).
3. Remove the access panel (on page 16 ).
4. Open the FBDIMM slot latches.
5. Install the FBDIMM.
To remove FBDIMMs, reverse the installation procedure. For FBDIMM slots 1 and 2, remove the air baffle,
if necessary. Refer to the instructions located on the air baffle.
Hard drive option
The server blade supports up to two hot-plug SFF SAS or SATA drives.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server blade or the
enclosure unless all hard drive and device bays are populated with either a component or a blank.
To install the component: