HP Ethernet 10Gb 2-port 530T Adapter - Manual (Page 36)

Scripting mode 36
IP Address = < xxx::xxx:xxx.xxx.xxx.xxx IPv6 address> ; Current = ::
;Configure Target TCP Port Number:
TCP Port = <Integer (1 to 65535)> ; current = 3260
;Configure Target Boot LUN Number:
Boot LUN = <Integer (0 to 255)> ; current = 0
;Configure iSCSI Name:
iSCSI Name = < String (0 to 128 Chars) > ; current =
;Configure CHAP ID:
CHAP ID = < String (0 to 128 Chars) > ; current =
;Configure CHAP Secret:
CHAP Secret = < String (12 to 16 Chars) > ; current =
[Secondary Device Parameters]
;Select Secondary Device:
Secondary Device = < xx:xx:xx:xx:xx:xx > ; Current =
00:00:00:00:00
:00
;Use Independent Target Portal when Multipath I/O Mode is Enabled:
Use Independent Target Portal = < Enabled | Disabled > ; Current = Disabled
;Use Independent Target Name when Multipath I/O Mode is Enabled:
Use Independent Target Name = < Enabled | Disabled > ; Current = Disabled
[Section FCoE Boot Main Menu]
[General Parameters]
;Enable/Disable Booting to FCoE Target after Logon:
Boot to FCoE Target = < Disabled | Enabled | One Time Disabled > ; Current
=
Enabled
;Enable/Disable Target Appears as First Hard Drive in The System:
Target as First HDD = < Enabled | Disabled > ; Current = Disabled
;Configure Link Up Delay Time in Seconds:
Link Up Delay Time = <Integer (0 to 255)> ; current = 0
;Configure Number of Retries in 2s Interval When LUN is Busy:
LUN Busy Retry Count = <Integer (0 to 60)> ; current = 0
;Configure Fabric Discovery Retry Value:
Fabric Discovery Retry = <Integer (0 to 8)> ; current = 4
;Enable HBA Boot Mode:
HBA Boot Mode = Enabled ; Read Only
[No.1 Target Parameters]
;Enable/Disable Target Establishment:
Connect = < Enabled | Disabled > ; Current = Disabled