HP Ethernet 10Gb 2-port 530T Adapter - Manual (Page 12)

Menu mode 12
MBA Configuration Menu
The following table shows MBA configuration options.
MBA configuration
parameter
Description
Option ROM* Enable/disable option ROM for a running device
Boot Protocol Specify the boot protocol of the device
Boot Strap Type Specify the boot strap type of the device
Hide Setup Prompt Enable/disable MBA banner display during system boot
Setup Key Stroke
Specify key strokes to invoke CCM menu during system boot
Banner Message
Timeout
Specify the seconds of MBA banner display time
Link Speed Specify the MBA link speed of the device
Pre-boot Wake On LAN Enable/disable the device pre-boot wake on LAN
VLAN Mode
Enable/disable VLAN mode
VLAN ID Specify VLAN ID (valid when VLAN mode is enabled)
Boot Retry Count Specify MBA boot retry times when boot fails before returning to BIOS (not supported
on NX1 devices)
Blink LEDs
LED on NIC card blinks to identify mapping between the menu entry with the physical
card location (not supported on 10G card)
*Feature not supported by HP adapters.