HP Ethernet 10Gb 2-port 530T Adapter - Manual (Page 15)

Menu mode 15
General Parameters menu
The General Parameters menu describes the iSCSI boot general parameters available for configuration.
The following table describes iSCSI boot general parameter configuration options.
iSCSI boot parameter Description
TCP/IP Parameters via
DHCP
Enable/disable iSCSI boot initiator to acquire IP address via DHCP
iSCSI Parameters via
DHCP
Enable/disable iSCSI boot initiator to acquire iSCSI target parameters via DHCP
CHAP Authentication Enable/disable CHAP authentication
Boot to iSCSI target* Enable/disable device to boot from iSCSI target after successful iSCSI login to iSCSI
target (not applicable for BCV-based iSCSI ROM)
DHCP Vendor ID Specify DHCP vendor ID
Link Up Delay Time Specify seconds that iSCSI boot initiator delays before attempting to connect to the
target
Use TCP Timestamp Enable/disable TCP timestamp
Target as First HDD*
Specify the iSCSI target drive targeted as first HDD in system (not applicable for
BCV-based iSCSI ROM)
LUN Busy Retry Count Specify number of retry attempts if iSCSI target reports a LUN busy condition
IP Version
Specify IP version
HBA Boot Mode Enable/disable HBA boot mode (only visible for devices with a valid offload license)
*Feature not supported by HP adapters.