HP Ethernet 10Gb 2-port 530T Adapter - Manual (Page 21)

Menu mode 21
General Parameters menu
The FCoE boot General Parameters menu describes the parameters available for configuration.
The following table describes FCoE boot general parameter configuration options.
FCoE boot parameter Description
Boot to FCoE target*
Enable/disable device to boot form FCoE target after connecting to the FCoE target
Target as First HDD* Enable/disable FCoE target to be treated as first HDD in the system (not applicable for
BCV-based FCoE ROM)
Link Up Delay Time
Specify seconds the FCoE boot initiator delays before attempting to connect to the
target
LUN Busy Retry Count Specify number of retry attempts if FCoE target reports a LUN busy condition
Fabric Discovery Retry Specify retry times before quitting fabric discovery
HBA Boot Mode
Enable/disable HBA boot mode
*Feature not supported by HP adapters.