HP Ethernet 10Gb 2-port 530T Adapter - Manual (Page 33)

Scripting mode 33
Subsystem Device ID = 0x1200
[Section iSCSI Boot Main Menu]
[Initiator Parameters]
CHAP Secret = ************ ;[L277] Old Value = *****...*****
;***********************************************************************
; Total 1 DIFFERENCES Detected
;***********************************************************************
NOT Saved; 0 Err, 0 Wrn, 1 Dif
CONGRATULATIONS: Script File Check Passed
-getItemGuide operation
E:\ccm2>ccmcfg32.exe -card 2 -getItemGuide -stdout
;***********************************************************************
;CCMCFG32 v6.0.2 - Comprehensive Configuration Utility
;Copyright (C) 2000-2010 Broadcom Corporation
; Dumping Configuration Item Guide of Device [00:10:18:3E:01:24] to STDOUT
;***********************************************************************
[Device Parameters]
MAC Address = 00:10:18:3E:01:24
PCI Function Number = 07:00:00
Device Type = BCM57712
Vendor ID = 0x14E4
Device ID = 0x1662
Subsystem Vendor ID = 0x14E4
Subsystem Device ID = 0x1200
[Section Device Hardware Configuration]
;Configure PHY Selection Policy:
PHY Selection Policy = < Hardware Default | First PHY | Second PHY | First
PHY
P
riority | Second PHY Priority > ; Current = Second PHY
[Section MBA Configuration Menu]
;Enable/Disable Option ROM:
Option ROM = < Enabled | Disabled > ; Current = Enabled
;Select Boot Protocol:
Boot Protocol = < Preboot Execution Environment (PXE) | Remote
Program
Load (RPL) | Bootstrap Protocol (BOOTP) | iSCSI | FCoE | None > ; Current
=
iSCS
I
;Select Boot Strap Type:
Boot Strap Type = < Auto | BBS | Int18h | Int19h > ; Current = Auto
;Configure Whether Setup Prompt is Displayed during ROM Initialization:
Hide Setup Prompt = < Enabled | Disabled > ; Current = Disabled
;Configure Key Strokes to Invoke This Configuration Menu:
Setup Key Stroke = < Ctrl-S | Ctrl-B > ; Current = Ctrl-S