HP XP Array Manager Software - Manual (Page 30)

2. See Table 5 , page 30 for a description of the error code.
For details about the error codes that are not described in Table 5 , page 30, contact your HP
Service Representative (see Calling HP Technical Support ).
Table 5 Error Codes and Error Contents When Using RAID Manager
Description Error Code (SSB2) Error Code (SSB1)
The setting failed because the specified volume does not
exist.
B9BD B9BF/B9BD
The specified volume is a command device. B9C2
The command was rejected due to one of the following
reasons:
B9C4
• The specified volume is a P-VOL or S-VOL of XP Snap-
shot
• The specified volume is a virtual volume.
• The specified volume is a pool volume.
• The specified volume is an S-VOL of XP XP Continuous
Access Journal.
• The specified volume is a journal volume.
• The specified volume is reserved for the XP Auto LUN
function.
• The specified volume is a P-VOL or S-VOL of XP XP
Business Copy.
• The consumed capacity exceeded the licensed capacity.
• The access attribute cannot be changed because the
data retention term is set.
• The specified volume is a command device.
• The specified volume is in the PAIR or COPY status.
• The specified volume does not exist.
• The S-VOL Disable attribute is set to the specified
volume.
• The reserve function cannot be canceled by RAID
Manager.
The Data Retention Utility is not installed. B9C7
The consumed capacity exceeded the licensed capacity. B9C9
Either:
B9CA
• More than 60 years are set as the data retention days,
or
• The other interface updated the settings while the Data
Retention Utility was changing the settings (Java conflic-
ted with the other interface).
The data retention term cannot be set because the access
attribute is set to Read/Write.
B9CB
Troubleshooting 30