HP Virtual Connect Enterprise Manager Software - Manual (Page 63)

1. Click the Bays tab.
2. To determine the power status of the bay, click the bay number. A status window appears.
3. Depending on the power status of the bay, perform one of the following steps:
•
If the bay is currently powered down, then proceed to the Assigning a profile to a bay procedure
section.
•
If the bay is currently powered up, then click Momentary Press, which automatically powers
down the bay.
•
If the bay is currently powered up and clicking Momentary Press does not power down the bay,
then click Press and Hold.
CAUTION: Only use the Press and Hold option when other attempts to powering down the bay have
failed, such as attempting to shut down physical bay instead of remotely.
Figure 6-3 Bay status with tab and hold
Assigning a profile to a bay
You can assign a profile to a bay only if the bay is not already associated with a server profile and if the
server is powered down. To assign a profile to a bay:
1. Click the Bays tab.
2. (Optional) From the Filter list, select VC Domain or VC Domain Group, and click Filter.
3. Select the bay.
4. Click Assign profile. The Assign Profile page appears.
5. Select an unassigned profile.
6. Click OK. The Virtual Connect Enterprise Manager is executing the request message
appears.
7. Click OK to go to the Jobs page and monitor job progress.
Unassigning a profile from a bay
You can only unassign a profile from a bay if the bay is associated with a server profile and if the server is
powered down. To unassign a profile from a bay:
Bays 63