HP Integrity NonStop J-Series - Manual (Page 122)

Primary Path
Indicates whether the primary disk path is active or inactive. Access State
Displays the configured location of the FCSA FSAC containing the primary disk
path controller. This attribute is displayed even if the physical FCSA FSAC is not
present.
Example: FCSA.SAC-1.GRP-111.MOD-2.SLOT-2
Configured FSAC Location
Identifies the primary FCSA that manages the disk.
Example: FCSA FSAC (111.2.2.1) FSAC
Backup Path
Indicates whether the backup disk path is active or inactive. Access State
Displays the configured location of the FCSA FSAC containing the backup disk
path controller. This attribute is displayed even if the physical FCSA FSAC is not
present.
Example: FCSA.SAC-1.GRP-111.MOD-3.SLOT-2
Configured FSAC Location
Identifies the backup FCSA that manages the disk.
Example: FCSA FSAC (111.3.2.1) FSAC
Firmware
The firmware product ID assigned by the supplier. OEM Product ID
The version of the firmware running on the disk. Version
Actions
Abort Backup Path
Terminates operation of the backup path to the disk. When the Abort action finishes, the path is
in a Hard Down state. You must use the Reset Backup Path action before you can start the path
again.
Abort Disk
Terminates operation of all paths for the disk. When the Abort action finishes, the paths are in a
Hard Down state. You must use the Reset Disk action before you can start the paths again.
Abort Primary Path
Terminates operation of the primary path to the disk. When the Abort action finishes, the path is
in a Hard Down state. You must use the Reset Primary Path action before you can start the path
again.
Blink LED Off
Turns off the blinking of the disk drive’s (amber) fault LED.
SCF Equivalent: SCF Control SAC $ZZSTO.#sac-name, deviceid(shelf,bay), LED OFF
Blink LED On
Causes the disk drive’s (amber) fault LED to start blinking.
SCF Equivalent: SCF Control SAC $ZZSTO.#sac-name, deviceid(shelf,bay), LED ON
122 System Resources