HP OneView for VMware vCenter - Manual (Page 64)

•
Host Mode
HP StoreVirtual—Not applicable ◦
◦ HP 3PAR StoreServ—Not applicable
◦ HP EVA—Host mode assigned to the HP EVA host object
◦ HP MSA 2000 G2/HP MSA P2000 G3—Name of the host's profile
◦ HP XP P9000/HP XP—Host mode assigned to the host group
◦ HP StoreOnce Backup—Not applicable
•
Preferred Path
HP StoreVirtual—Not applicable ◦
◦ HP 3PAR StoreServ—Not applicable
◦ HP EVA—Specifies whether the path uses a port on the controller that is configured as
the preferred path for the vdisk (Yes, No, No preference)
◦ HP MSA 2000 G2/HP MSA P2000 G3—Not applicable
◦ HP XP P9000/HP XP—Not applicable
◦ HP StoreOnce Backup—Not applicable
•
Active Path—Specifies whether the path is active or in standby status
If a path is active and then goes offline, a standby path takes over.
•
Path ID—Path ID assigned by VMware
•
VMware Disk Identifier—Disk name assigned by VMware
Viewing replications
The replications page displays the following information:
•
Source Disk Name—Source replication disk
•
Source Array—Array identifier for the local (source) array; displayed only for Continuous
Access replications and not supported for HP MSA 2000 G2/HP MSA P2000 G3 arrays
•
Replication Type—The type of replication used:
HP StoreVirtual—Snapshot, Remote Snapshot ◦
◦
HP 3PAR StoreServ—Virtual copy, Physical copy
◦ HP EVA—Snapshot, Snapclone, Mirrorclone, Continuous Access
◦ HP MSA 2000 G2/HP MSA P2000 G3—Not applicable
◦ HP XP P9000/HP XP—P9000 or XP Business Copy, P9000 or XP Snapshot, P9000 or
XP Continuous Access
◦ HP StoreOnce Backup—Not applicable
•
Replica Name—Target replication disk
•
Replica Array—Array identifier for the remote (target) array; displayed only for Continuous
Access replications and not supported for HP MSA 2000 G2/HP MSA P2000 G3 arrays
•
Replica Status—Status of the replica (for example, PAIR, SUSPEND, SYNCHED, or COPY)
64 Using Insight Control for vCenter