Adding the data path, Verify the tape configuration – HP Integrity NonStop H-Series User Manual
Page 66
Configuring the M8706A Tape Drive for the NonStop
BladeSystem Server
SL500 (M852x) Tape Library Installation and User’s Guide—541531-010
B- 2
Adding the Data Path
Adding the Data Path
Issue an SCF ADD TAPE command to configure the tape drive. This is an
example:
-> ADD TAPE $M8706A, SENDTO STORAGE, CLIM C1002531, LUN 1
You can specify backup and primary CPUs if you need to balance the
processing load to other CPUs.
After the tape drive is added, use the START command to start it:
->
START TAPE $M8706A
Verify the Tape Configuration
To check that the tape drive was successfully added, issue the SCF STATUS tape-
name, detail command:
->
STATUS TAPE $M8706A, DETAIL
STORAGE - DETAILED STATUS TAPE \OSMQA5.$M8706A
Tape Process Information:
Tape I/O Process Information:
Library File.......
Program File....... $SYSTEM.SYS00.OTPPROCP
Current Settings:
LDev
State
Primary PID
Backup PID
DeviceStatus
197
STARTED
0,322
1,351
ONLINE, BOT
ACL................ NOT INSTALLED
Buffer Level...... RECORD
Checksum Mode...... NORMAL I/O
*Compression....... ON
*Density............ 38000
Media Type........ Not applicable
Opens.............. 0
*RecSize........... 2048
Short Write Mode... ALLOWED, PADDED
SubType........... 18
Volume Switching... TRANSPARENT