HP Netserver E Server series - Manual (Page 72)

Chapter 8 Configuring the HP NetServer
66
existing Administrator password, then refer to "Resetting Lost
Passwords" in Chapter 10, "Troubleshooting."
NOTE You must set the Administrator password before setting the
User password. The Administrator password is the only
password required to configure the HP NetServer to boot with
a password.
4. Press the Enter key to enter a new password or change the old one.
A pop-up menu appears titled, "Set Power-On Password". If no password
has been entered, the field "Enter new password: [ ]" is highlighted. If
a previous password has been entered, the field "Enter old password:
[ ]" is highlighted.
NOTE To leave the pop-up menu without entering a password, press
the Esc key at any time.
5. Enter the password (new or old) in the appropriate field and press Enter.
The password is accepted and the next field just below it, "Re-enter new
password: [ ]" or "Enter new password: [ ]" field is highlighted.
For security reasons, the password does not appear on the screen.
6. If necessary, enter the new password in the "Enter new password: [ ]"
field and press Enter.