HP IO Accelerator for BladeSystem c-Class - Manual (Page 49)

Utilities 49
Data Volume Information: If the -d option is used, then the following data volume information is reported in
addition to the basic information:
• Physical bytes written
• Physical bytes read
All Information: If the -a option is used, then all information is printed, which includes the following
information in addition to basic and data volume information:
Adapter information:
• Manufacturer number
• Date of manufacture
• Power loss protection status
• PCIe bus voltage (avg, min, max)
• PCIe bus current (avg, max)
• PCIe power limit threshold (watts)
• PCIe slot available power (watts)
• PCIe negotiated link information (lanes and throughput)
Block device information:
• Part number
• Manufacturer's code
• Manufacturing date
• Vendor and sub-vendor information
• Size of the device, out of total capacity
• Format status and sector information (if device is attached)
• FPGA ID and Low-level format GUID
• PCIe slot available power
• PCIe negotiated link information
• Card temperature, in degrees Centigrade
• Internal voltage: avg. and max.
• Auxiliary voltage: avg. and max.
• Percentage of good blocks, data and metadata
• Lifetime data volume statistics
Error Mode Information: If the IO Accelerator is in minimal mode, read-only mode, or write-reduced mode
when fio-status is run, the following differences occur in the output:
• Attach status is Status unknown: Driver is in MINIMAL MODE:
• The reason for the minimal mode state is displayed (such as Firmware is out of date. Update
firmware.)
• Geometry and capacity information not available. appears.
• No media health information appears.