HP IO Accelerator for BladeSystem c-Class User Manual
Hp io accelerator version 3.2.3 windows user guide
Advertising
HP IO Accelerator Version 3.2.3 Windows
User Guide
Abstract
This document describes software requirements for all relevant HP IO Accelerators using Microsoft Windows operating systems. This document is
intended for system administrators who plan to install and use HP IO Accelerators with a Microsoft Windows operating system. It is helpful to have
previous experience with HP IO Accelerators and a Microsoft Windows operating system. This user guide is intended for IO Accelerator software
release 3.2.3 or later.
Part Number: 647099-003
February 2013
Edition: 3
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- HP IO Accelerator Version 3.2.3 Windows User Guide
- Abstract
- Notice
- Contents
- About this guide
- Introduction
- Windows Server environments
- Installation overview
- Uninstalling a previously-installed driver
- Installing software on a Windows operating system
- Upgrading device firmware from VSL 1.x.x or 2.x.x to 3.x.x
- Manual installation on Windows Server
- Upgrading the device firmware using Windows
- Upgrading driver software using Windows
- Defragmentation
- Silent install option
- Outdated firmware check
- Enabling PCIe power
- IO Accelerator naming
- Adding a file system, formatting, and performing multi-disk configuration
- Creating a RAID configuration
- Using the IO Accelerator as swap with Windows operating system
- Setting up SNMP for Windows operating systems
- Using installation logs
- Maintenance
- Utilities
- Monitoring IO Accelerator health
- Trim support
- Using Windows page files with the IO Accelerator
- Performance and tuning
- NUMA configuration
- Resources
- Support and other resources
- Regulatory information
- Acronyms and abbreviations
- Documentation feedback
- Index