HP Hitachi Dynamic Link Manager Software - Manual (Page 111)

HiCommand ® Dynamic Link Manager (HDLM) for Windows ® Systems User’s Guide 95
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : off
Remove LU : off
Intermittent Error Monitor : off
HDLM Manager Ver WakeupTime
Alive xx-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive xx-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive xx-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name = view, completion
time =
yyyy/mm/dd hh:mm:ss
Installing HDLM After MSCS Installation
To install HDLM on a host that does not currently contain HDLM:
1. Install MSCS on the host.
2. Restart the host.
3. Log on to Windows as a member of the administrators group.
4. Store the license key file directly under the Windows installation-destination drive. You
can also specify the license key directly without using the license key file.
installation-drive:\hdlm_license
The license key file will be deleted when the installation finishes.
5. Perform the installation.
– If you do not want to perform an unattended installation, insert the CD-ROM into the
drive, and start the installation program setup.exe.
If HDLM has been installed, the KAPL09129-E message appears. In this case, perform
the procedure shown in section 3.6.5. If HDLM 5.5 or later has been installed, the
KAPL09173-W message appears. In this case, perform the procedure shown in section
3.6.4. If no message appears, go to step 6.
– If you want to perform an unattended installation, insert the CD-ROM into the drive,
and start the installation program installhdlm.exe.
At the command prompt, execute the following command:
drive-to-which-the-installation-CD-ROM-is-
inserted:\DLMTools\installhdlm.exe -f installation-information-settings-file
(installhdlm.ini)
Specify n (do not restart) for the restart key in the installation-information
settings file.
This command checks whether HDLM has already been installed. If HDLM 5.4 or
earlier has been installed, the KAPL09129-E message appears. In this case, carry out
the procedure shown in section 3.6.5. If HDLM 5.5 or later has been installed, an
upgrade installation is performed, and then the KAPL09183-I message appears.
After the installation is complete, go to step 14.