HP ProLiant DL380 G5 Server User Manual
Page 69
•
Serial Number—Displays the Physical serial number of the device or client system board. Use this number for
identification and registration purposes. N/A appears if you do not have a device or client that supports the
asset management feature. Use the System Configuration Utility (or the appropriate utility for your device or
client) to enter a system serial number if one does not appear and you have a device or client that supports the
asset management feature.
•
Virtual Serial Number—Displays the Logical serial number of the device or client system board. This field won't
be available if you do not have a device that supports this feature.
•
Bus Type—Identifies the device or client bus type as EISA, EISA/PCI, PCI, PCI-X or PCI Express.
•
Board Rev—Displays the system board revision number.
CPUs
The following information about each processor in the system is available in this window. This information may vary
depending on device type.
•
Processor—Lists the type of processor and its speed. For devices, the colored ball indicates the status of each
processor.
•
Co-processor—Displays the type and speed of the coprocessor on the device or client PC, such as 80387 at 33
MHz, or W 3167 at 33 MHz.
•
Slot—Lists the number of the slot where the processor is installed. Use this information for identification
purposes.
•
Slot 0—Indicates that a CPU or a memory module is connected directly to the system board and not in an
expansion board.
•
Socket—Displays the currently selected processor’s socket. Use this information for identification purposes.
•
Cache—Displays the amount of device or client hardware cache available. For example, Cache L2: 64KB
indicates 64 KB of secondary level cache between the processor and system memory.
•
Action—Indicates what action, if any, should be taken for the currently selected processor. Possible values
include No Action Needed, and Replace CPU.
•
Step—Displays the revision level of the processor.
•
Cores—Indicates the number of cores present in this processor
•
Threads—Indicates the number of threads present in this processor
•
Hyper-Thread—Indicates whether hyper-threading is enabled or disabled. When Hyper-Threading enabled a
single processor act as two logical processor and the Operating Systems view it as two processor
NOTE:
Contact your Compaq/HP authorized re-seller or Hewlett Packard Corporation regarding Pre-
Failure Warranty to see if the module is under warranty.
Memory
This section displays the following information about the Device memory information:
•
Total Memory [KB] —The total amount of memory available on the device or client PC, such as 8192 KB.
•
Correctable Memory—Memory errors are corrected by the Error Correcting Code (ECC) memory subsystem
when they occur. The Correctable Memory field displays the status of the Correctable Memory as one of the
following.
•
Logging—ECC memory correction is supported and error logging is enabled.
•
Disabled—ECC memory correction is supported, but errors are not logged for this device.
When a certain rate of errors is exceeded the health driver automatically disables logging of these errors, and
sends an alarm. The errors are corrected, but are no longer logged. Logging is re-enabled when the driver is
reloaded or the operating system restarts.
•
Not Supported—Logging of correctable memory errors is not available for this device. Either the device does not
support ECC memory or the driver is not loaded.
•
Unknown—You may need to upgrade the driver software and/or Server Agents. The Server Agent cannot
determine the status of the devices.
Advanced Memory Protection
This section displays the following information about the Advanced Memory Protection sub-system.
•
Advanced Memory Protection Status—Displays status of the Advanced Memory Protection sub-system. The
following states are supported:
Agent information 69