HP NonStop G-Series - Manual (Page 22)

Setting Up the ACL Tape Drives
M8501 and M8502 ACL Tape Drive Installation and User’s Guide — 529972-003
2 -2
Setting Up the M8501 ACL Rackmount Unit
a. Push back the tabs in the top of the template and place them in the correct
holes in the mounting rack. Match up the hole pattern indicated on the sides of
the template with the hole pattern in the mounting rack.
b. Make sure to begin measuring in the correct place. If a unit is already installed
immediately below the planned position of the new unit, then place the
template against the front of the mounting rack and rest it on top of the
previously installed unit.
c. Use the front of the template to mark the attachment points for mounting
brackets, rails, components, or cage nuts on the back of the storage cabinet.
d. Use the back of the template to mark the attachment points for the mounting
brackets, rails, components, or cage nuts on the back of the storage cabinet.
3. Remove the template.
4. Install the slide members for the rackmount unit.
5. If the slide members are already installed, attach the front and rear mounting
brackets to the outer and middle slide members.