HP 3PAR Operating System Software - Manual (Page 11)

1. Click Stop to stop the Apply Settings process and return to the Service Processor Setup wizard.
2. Click the Prev button until you reach Step 2: SP Networking.
3. Determine an available IPv4 address to use for the Service Processor and enter that IP address
in the IP Address text box.
4. Click the Next button until you return to Step 7: Apply Settings. (You do not need to re-enter
any other Service Processor settings.)
The wizard will automatically begin to apply the settings again.
Troubleshooting “Page Not Found” IP Address Issues
If the Service Processor displays a Page Not Found or similar message, the permanent Service
Processor IP address you entered is not a valid address. You must set up the Service Processor
again.
•
If you are using a physical Service Processor:
Return to the Set IP Address wizard and set up a new, valid IP address. For more
information, see the HP 3PAR StoreServ 7000 Storage Installation Guide.
To access the HP 3PAR StoreServ 7000 Storage Installation Guide, go to the HP 3PAR
support site:
1.
http://www.hp.com/3par/support_manuals
2. Use the new permanent IP address to restart the Service Processor Setup wizard. For more
information, see
“Setting Up the Service Processor” (page 8) .
3. Proceed through the Service Processor Setup wizard, re-entering your Service Processor
settings. (The Service Processor ID is already set; you do not need to reset the ID.)
•
If you are using a virtual Service Processor:
Use the temporary SP IP address to restart the Service Processor Setup wizard. For more
information, see
“Setting Up the Service Processor” (page 8) .
1.
2. Proceed through the Service Processor Setup wizard, re-entering your Service Processor
settings. (The Service Processor ID is already set; you do not need to reset the ID.)
Verifying the HP 3PAR OS on the Service Processor
To check the version of the HP 3PAR OS installed on your Service Processor, use the SPmaint
module in SPOCC to display the SP version.
To add the HP 3PAR OS, use the SPmaint module in SPOCC to upgrade the HP 3PAR OS:
1. Log into SPOCC (https://<SP IP>).
2. Click SPmaint
→InServ Product Maintenance.
3. Select your storage system.
4. Click Upgrade HP 3PAR OS.
For more information, see the HP 3PAR Service Processor Onsite Customer Care (SPOCC) User’s
Guide. To access this document, go to the HP 3PAR support site:
http://www.hp.com/3par/support_manuals
Continuing to the Storage System Setup Wizard
After you complete configuration of the Service Processor, you must set up the HP 3PAR StoreServ
Storage system.
To access the Storage System Setup wizard and set up the HP 3PAR storage system:
1. Click Finish to exit the Service Processor Setup wizard.
2. Return to the SmartStart wizard.
3. Continue to “Setting Up the HP 3PAR StoreServ Storage System” (page 12) .
Verifying the HP 3PAR OS on the Service Processor 11