Part i using smartstart to configure storage – HP 3PAR Operating System Software User Manual
Page 3
Part I Using SmartStart to Configure Storage
“Prepare to Configure” (page 5)
1.
Gather the information you’ll need to use SmartStart to
configure your HP 3PAR StoreServ 7000 Storage system.
Part II “Understanding Storage”
2.
Learn more about how HP 3PAR storage systems work.
NOTE:
If you are not familiar with HP 3PAR storage systems,
HP highly recommends you read this short introduction.
“Setting Up the Service Processor” (page 8)
3.
Set up the Service Processor and the HP 3PAR StoreServ 7000
Storage system.
“Setting Up the HP 3PAR StoreServ Storage System” (page 12)
“Connect to the HP 3PAR StoreServ 7000 Storage System” (page
16)
4.
Connect to your new storage system
“Configure the Hosts” (page 17)
5.
Configure Fibre Channel host connections or iSCSI host
connections.
6.
Create storage, and add the ability to use virtual volumes on
Windows 2008 R2 server host systems.
“Install the HP 3PAR Management Console” (page 32)
7.
Install the HP 3PAR Management Console in order to manage
storage and access additional features and functionality.