HP 3PAR Operating System Software - Manual (Page 6)

password to gain administrator access to both the system running SmartStart (the local
host) and the remote host.
◦ Rights to configure storage
To configure storage, your user account on the HP 3PAR storage system must be assigned
either a Super or Edit role, or be granted these rights: host_create, vv_create, and
vlun_create.
◦ HP 3PAR storage system and Service Processor information necessary for initialization
and configuration
For more information, see your completed Storage System Software Installation Checklist
from the HP 3PAR StoreServ 7000 Site Planning Manual.
Service Processor information:
– The Service Processor IP address, subnet mask, and gateway IP address
For more information on determining the temporary IP address and assigning the
permanent IP address, see the HP 3PAR StoreServ 7000 Storage Installation Guide.
– Hostname to assign
– DNS settings (if applicable)
– Proxy server settings (if applicable)
– New password to assign to the username for the two system setup wizards (setupusr)
– New password to assign to the username for the Service Processor (3parcust)
HP 3PAR StoreServ Storage system information:
– Storage system serial number
This 7-digit number is located on the back of your HP 3PAR StoreServ Storage system
next to the power switch for the node enclosure PCM, and begins with 16 (e.g.,
1624635).
– Storage system name
– IP address (IPv4 only)
– Subnet mask
– Gateway IP address
– New password to assign to the username for the storage system (3paradm)
CAUTION: Do not run more than one instance of SmartStart on the same host system. Running
multiple instances of SmartStart can cause resource conflicts and operating errors.
About Storage
Learn more about how storage works on your new HP 3PAR storage system before you begin to
use SmartStart to install and set up your HP 3PAR StoreServ 7000 Storage system:
Part II “Understanding Storage”
FAQ
1 What is HP 3PAR SmartStart?
6 Prepare to Configure