Attaching a macintosh printer cable – HP LaserJet 6pmp Printer series User Manual
Page 20
Advertising
Attaching a Macintosh Printer Cable
You can directly connect the printer to a
Macintosh (or Macintosh-compatible)
computer using either a LocalTalk or
Macintosh serial cable.
N o t e
To connect the printer to a LocalTalk
Network, see Appendix C.
C a u t i o n
Make sure power is off.
1
Locate the interface cable door (
A
) at
the back of the printer.
2
Pull the door out using the finger tab
for leverage.
3
Plug the cable into the printer’s
LocalTalk port. If the cable does not
slip on easily, make sure the pin
orientation matches the illustration.
4
Replace the interface cable door
while allowing the cable to feed
through the top hole.
5
Connect the other end of the cable to
the proper connector on the computer.
1
Pr
inter
S
et
up
EN
Printer Setup
1-11
Advertising