HP Lights-Out 100 Remote Management - Manual (Page 26)

26 HP ProLiant DL145 Lights-Out 100i Remote Management User Guide
Command Action
state Displays the current setup
information
delay Sets the delay between two pings
from the remote management
processor
length Sets the default ping packet length
rtadd Manually adds an IP route to the
table
rtdel Manually deletes an IP route from the
table
routes Displays the IP route table
setip
xxx.xxx.xxx.xxx
yyy.yyy.yyy.yyy,
where
xxx.xxx.xxx.xxx
is the IP
address and
yyy.yyy.yyy.yyy
is the subnet
mask Sets the remote management
processor IP address and subnet
mask
setdgw Sets the remote management
processor default gateway to Enable
DHCP or Disable DHCP
dhcp Obtains an IP address automatically
setdl Sets LAN downloader configuration
vsi Displays the virtual floppy
configuration
setvsi Sets the virtual floppy configuration
help general Displays menu help
help diagnostics Displays diagnostic commands
help telnet Displays telnet commands
firewall Displays the current firewall settings
setfirewall Sets the firewall parameters