HP Lights-Out 100 Remote Management - Manual (Page 9)

Configuration 9
6. Press the Esc key to return to the previous screen, or press the F10 key to
save the changes and exit Setup.
Using the dedicated management port
The dedicated management port is a standard Ethernet 10Mb interface and is
connected to the network using a standard Ethernet cable. Before using the
dedicated management port you will need to determine either the DHCP IP
address, set a static IP address, or use the default static IP address.
To obtain a DHCP IP address from BIOS setup:
1. Connect a standard Ethernet cable between the onboard NIC on the server
rear panel and a network jack. By default, the remote management processor
has DHCP enabled and automatically negotiates an IP address. To view the
DHCP IP address, run the BIOS setup program or retrieve the DHCP IP
address using CLI through the serial port connection.
2. Power on the server by pressing the power on/off button on the front panel.
3. When POST displays the message Press <F10> if you want to
run SETUP, press the F10 key. If the server has an administrator password
configured, the system prompts you to enter the password. If the server does
not have a password configured, the main screen of the BIOS Setup Utility
appears.
4. Press the right arrow (
→
) key to navigate to the Advanced menu.
5. Press the down arrow (
↓
) key to scroll to the Management Processor
Configuration menu. Press the Enter key.
6. Press the down arrow (
↓
) key to scroll to the Set LAN Configuration menu.
Press the Enter key.
7. Press the down arrow (
↓
) key to scroll to the IP Address menu. Press the
Enter key.
8. Note the DHCP assigned IP address for future reference.
9. Press the Esc key to return to the previous screen or press the F10 key to
save the changes and exit Setup.
To obtain a DHCP address from the CLI: