HP Command View for Tape Libraries Software - Manual (Page 191)

“show ssh hostkeys” (page 243) “set ssh hostkeys” (page 218)
“show station” (page 244) “show station” (page 244)
show supportticket cache set supportticket disable
show supportticket policy set supportticket enable
show supportticket statistics set system contact assetnumber
show system contact assetnumber set system contact email
show system contact email set system contact location
show system contact location set system contact name
show system contact name set system contact pager
show system contact pager set system contact phone
show system contact phone set system name
show system info show drive access
show system name show drive hostport
show system status show drive info
synch secmgr show drive interface
unmap host show drive productid
show drive revision
clear station
Description Clears any management station registered with the Interface Manager. Use
this command when removing a library from its primary management station.
Syntax clear station
Availability All users and modes
Operands None
Examples To unregister the library associated with this Interface Manager from any
management station:
/>clear station
Management station cleared.
See also “show station” (page 244)
To get a management station to be the primary management station close Command View TL and
restart the service.
1.
Close the Command View TL browser.
2. Right-click on My Computer and select Manage.
3. Click Services and Applications, then Services.
4. Select the Command View TL service.
5. Click Restart the service.
6. Reopen the Command View TL program.
create host
Description Creates a reference to a HBA. This should only be used for hosts not currently
connected to any interfaces. If the specified host has already been created
using the specified node world wide name and port world wide name, no
changes are made. If there already exists a host with the specified host name,
no changes are made.
Syntax create host node_wwn node_wwpn host_name
Availability All users and mode
Operands Specify the node world wide name. World wide names are
specified as 16 hex digits. For example, node_wwn
1234567890ABCDEF is a well-formed world wide name.
This operand is required.
clear station 191