Set net v6 ipversion – HP Command View for Tape Libraries Software User Manual
Page 213
will run a wizard prompting users for
the prefix of the address to add or
remove.
Examples
To configure the Interface Manager’s public network interface by adding or
removing a network address:
/>set net v6 ipaddress remove
Remove IPv6 Address: Select Address
1) 2620:0000:0a07:e00a:0001:0002:0003:0004/64
2) 2620:0000:0a07:e00a:000a:000b:000c:000d/64
Enter a selection or 'Q' to quit [default='Q']: 2
Are you sure you wish to complete this remove operation
for 2620:0000:0a07:e00a000a:000b:000c:000d?
Enter 'y' to continue or 'n' to skip [default='n']: y
ipAddress =2620:0000:0a07:e00a:0001:0002:0003:0004/64
Operation status: Starting to change network.
Operation status: Finished Updating Network Settings
See also
set net v6 ipversion
NOTE:
To use this command, first enable IPv6 using the
command.
Description
Configures the Interface Manager card to use the specified IP protocol.
CAUTION:
Resetting your IP version may cause your Telnet/SSH session to
end. You will have to log on again.
NOTE:
The Interface Manager will obtain IPv6 addresses using stateless
address auto-configuration when IPv6 or dual stack is selected for the IP
protocol.
Syntax
set network v6 ipversion
[[ip4] | [ip6] | [ dualstack]
force
]
Availability
All users and modes
Operands
[[ip4] | [ip6] | [
dualstack] force
]
NOTE:
Dualstack
enables both IPv4 and IPv6 protocols.
Examples
To set the IP version:
/>set net v6 ipversion ipv6
Caution: Resetting the IP version may cause your CLI session
to terminate (for a telnet/ssh user), and you may have to log
on again.
Do you really want to change the IP version to IPv6?
Enter 'y' to continue or 'n' to skip [default='n']: y
Operation status: Starting to change network.
Operation status: Finished Updating Network Settings
See also
set net v6 ipversion
213