HP XP Array Manager Software - Manual (Page 38)

NOTE:
If you are using Windows, you can drag and drop the desired WWNs from Non-Monitor to Monitor.
When you drop a WWN at Monitor, the Add WWN window is displayed in which you can specify
the Performance Control name only.
Figure 13 The Add WWN Window
.
If you add a port or HBA to the storage system after you specify the settings, the traffic statistics related
to the connections to the newly added port or HBA will not be monitored. In this case, follow the
procedure above again to monitor all the traffic between HBAs and ports.
Up to 32 HBAs (WWNs) can be monitored for one port. If more than 32 HBAs are connected to one
port, the traffic related to HBAs will have to be excluded from the monitoring target. Consider the
intended use of each host and move the HBAs that you think not necessary to be monitored to
Non-Monitor status by following these steps.
To exclude traffic between an HBA and a port from the monitoring target:
1. Start XP Performance Control and ensure that the WWN tab is displayed ( Figure 4 on page 20).
2. Select All from the list at the top right corner of the window.
3. In the upper-left tree, double-click a port to which more than 32 HBAs are connected.
4. Double-click Monitor below the specified port.
5. Right-click the WWN of an HBA you want to exclude from the monitoring target and then select
Delete WWN from the pop-up menu.
If you are using Windows, you can drag and drop the desired WWNs icons from Monitor to
Non-Monitor.
XP Performance Control Operations 38