HP Traffic Director sa7220 - Manual (Page 185)

C H A P T E R 5 Policy Group Commands
173
config policygroup
service server port msap Enables or disables Multi-hop Source Address Preservation
(MSAP) on the named server.
config policygroup <policy-name> service
<service-name> server <server-name> port <port>
msap [enable | disable]
where:
•
policy-name is the name of an existing Policy Group
• service-name is the name of the service
• server-name is the name of the server
• port is the server port
• enable enables Multi-hop Source Address Preservation
• disable disables Multi-hop Source Address Preservation
config policygroup
service server port type
NOTE: A backup server is
sent requests only under two
circumstances: First, when
the primary servers are
unable to meet the
configured target response
times a backup server is
used if and only if "backups"
is enabled for this service.
Second, backup servers are
given requests when a
primary server is
unavailable. As primary
servers become inactive,
backup servers are brought
into service to handle
requests.
Specifies the server type of the named server.
config policygroup <policy-name> service
<service-name> server <server-name> port <port>
type [primary | backup | disable]
where:
•
policy-name is the name of an existing Policy Group
• service-name is the name of the service
• server-name is the name of the server
• port is the server port
• primary specifies that this server is a primary server
• backup specifies that this server is a backup server
• disable disables the server
Command Description