HP Traffic Director sa7220 - Manual (Page 151)

C H A P T E R 5 Routing Commands
139
Routing
Commands These commands are described later in this chapter.
config route ospf-area [backbone | <area>]
config route ospf-hello <nseconds>
config route ospf-dead <nseconds>
config route ospf-authtype [none | simple
ospf-authkey <simple key> | md5 [ospf-authkey
md5 <key> keyid <id>]
config route protocol [rip | ospf | disable]
config route rip-version [1 | 2]
config route role [standalone | primary |
backup]
Policy Group
Commands These commands are described later in this chapter.
config policygroup create <policy-name>
config policygroup delete <policy-name> | -all
config policygroup <policy-name> service
<service-name> header-names [certificate
<headername> |
cipher-used <headername> | source-ip
<headername> | ssl-id <headername>]
config policygroup <policy-name> throttle
[enable | disable]
Service
Commands These commands are described later in this chapter.
config policygroup <policy-name> service create
<service-name> vip <ipaddr> port <port> {type
[TCP | UDP | RICH_HTTP]} {sticky [disable|
src-ip | cookie]} {sticky-timeout <seconds>}
{backups [enable | disable]} {response
<milli-sec>} {priority <level>} {balancing
[load | robin]} {server-timeout <seconds>}
config policygroup <policy-name> service delete
[<service-name> | -all]
config policygroup <policy-name> service
<service-name> {enable} {disable}
{balancing[robin | load]}{sticky [disable |
src-ip | cookie]}
{sticky-timeout <nseconds>} {backups [enable |
disable]} {response <milliseconds>} {dup-syn
<microseconds>} {priority <level>}
{server-timeout <seconds>}
config policygroup <policy-name> service
<service-name> header