HP LaserJet 9000 Printer series - Manual (Page 10)

10 2 Finisher tasks ENWW
Configuring control panel settings
The device attaches to the left side of the HP printer. You can change
the default job offset and default stapler actions through the printer
control panel in the
CONFIGURATION OF MULTIFUNCTION FINISHER
menu.
Note The system administrator can limit access to the job-offset and default
stapler actions.
Note The offset function is available only in the stacker bin (bin 1) and only
for jobs that are not stapled.
You can select the available stapler action through the printer driver (for
example, use of one staple or two staples).
Offset actions
Offset Action: No When the OFFSET mode is off, all of the jobs are stacked with no
separation.
Offset Action: Yes When the OFFSET mode is on, the device automatically
separates complete jobs or mopies (multiple original prints of a
single job). Each job or mopy is separated by setting the jobs
apart from each other (for unstapled jobs).