HP LaserJet 9000 Printer series - Manual (Page 39)

ENWW Interpreting control-panel messages 39
STAPLE AREA
SAFETY
PROTECTION
ACTIVATED A staple safety alert has occurred. Remove any obstruction from
the stacker bin ejection area.
STAPLER LOW
ON STAPLES The stapler cartridge has 20 to 50 staples
remaining. Replace the staple cartridge if
you want to saddle stitch
more than 10 sets in a job.
STAPLER OUT
OF STAPLES The stapler cartridge contains no more
staples. Replace the stapler cartridge.
See “Loading the stapler
cartridge” on page 31.
TOO MANY PAGES
IN JOB TO
STAPLE The job height is greater than the stapler
capacity. The height of the job to be stapled
should not exceed 50 sheets of 20-lb bond. Verify that the job is within
specifications to be stapled.
See “Supported media types”
on page 53.
TOO MANY PAGES
TO MAKE
BOOKLET The page content is too large to be saddle
stitched. Verify that the job is within
specifications to be saddle
stitched.
13.12.11
JAM IN STAPLER A staple jam has occurred. Check for a jammed staple in
the staple cartridge.
13.12.21
13.12.22
13.12.23
JAM IN LEFT
ACCESSORY A paper jam exists in the flipper assembly. Check for jammed media in
the output area of the printer
or the input area of the
device.
13.12.31
13.12.32
13.12.33
13.12.34
JAM IN LEFT
ACCESSORY A paper jam exists in the paper-path area. Check for jammed media in
the output area of the printer
or the input area of the
device.
Control panel messages
Message Description Recommended action