HP ProLiant DL320 G3 Server - Manual (Page 41)

Hardware options installation 41
NOTE: Depending on the model purchased, the server or hard drive
may look slightly different than the illustration.
4. Resume normal server operations.
Installing non-hot-plug hard drives
CAUTION: To prevent improper cooling and thermal damage,
do not operate the server unless all bays are populated with either a
component or a blank.
1. Access the internal server components ("Preparation procedures" on page
20 ).
2. Remove the SATA backplane ("Removing the hot-plug SATA backplane" on
page 24 ), if previously installed.
3. Set the SCSI ID for the non-hot-plug SCSI hard drive. Refer to the
documentation that ships with the hard drive.
4. Remove the four screws pre-installed on the tray.