HP Radio Frequency Planner Software Series - Manual (Page 16)

Table of Contents
HP RF Planner User Guide
9
• Autodesk DWG Release 9, 10, 11, 12, 13, 14, 2000, 2002, 2004/2005/2006
Planner allows importing of the following information from an AutoCAD file.
• Layout Dimensions
• Layer Information
Planner supports the following shapes of objects. All these shapes must be 2D.
• Lines
• Rectangles
• Polygons
• Circles
• Arcs
However, Planner does not support the following shapes:
• Doughnut
• Hollow Arcs
• Curved Polygons
• Spline
• 3D objects
If you have block references in your drawing, planner does not explode the blocks on import. As a result, you will need to
explode the blocks in AutoCAD before importing the autoCAD drawing.
Refer to the RF Planner release notes for detailed description of pre-processing AutoCAD files before importing in
Planner.