Jams, Common causes of jams – HP LaserJet P2055dn User Manual

Page 118

Advertising
background image

Jams

Common causes of jams

Many jams are caused by using paper that does not meet HP specifications. For complete paper
specifications for all HP LaserJet products, see the HP LaserJet Printer Family Print Media Guide. This
guide is available at

www.hp.com/support/ljpaperguide

.

The product is jammed.

1

Cause

Solution

The paper does not meet specifications.

Use only paper that meets HP specifications. See

Paper and

print media on page 43

.

A component is installed incorrectly.

Verify that the print cartridge is correctly installed.

You are using paper that has already passed through a product
or copier.

Do not use paper that has been previously printed on or copied.

A tray is loaded incorrectly.

Remove any excess paper from the tray. Make sure that the
stack is below the maximum stack height mark in the tray. See

Load trays on page 50

.

The paper is skewed.

The tray guides are not adjusted correctly. Adjust them so they
hold the stack firmly in place without bending it.

The paper is binding or sticking together.

Remove the paper, flex it, rotate it 180°, or flip it over. Reload
the paper into the tray.

NOTE:

Do not fan paper. Fanning can create static

electricity, which can cause paper to stick together.

The paper is removed before it settles into the output bin.

Reset the product. Wait until the page completely settles in the
output bin before removing it.

During two-sided printing, you removed the paper before the
second side of the document was printed.

Reset the product and print the document again. Wait until the
page completely settles in the output bin before removing it.

The paper is in poor condition.

Replace the paper.

The internal rollers from the tray are not picking up the paper. Remove the top sheet of paper. If the paper is too heavy, it

might not be picked from the tray.

The paper has rough or jagged edges.

Replace the paper.

The paper is perforated or embossed.

Perforated or embossed paper does not separate easily. Feed
single sheets from Tray 1.

Product supply items have reached the end of their useful life. Check the product control panel for messages prompting you

to replace supplies, or print a supplies status page to verify the
remaining life of the supplies. See

Print the information

pages on page 70

.

Paper was not stored correctly.

Replace the paper in the trays. Paper should be stored in the
original packaging in a controlled environment.

1

If the product continues to jam, contact HP Customer Support or your authorized HP service provider.

106 Chapter 10 Solve problems

ENWW

Advertising
This manual is related to the following products: