HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem - Manual (Page 11)

Command line 11
Supported actions:
delete, help, set, show
Item Description
delete domain Delete the existing Virtual Connect domain configuration.
Deleting the domain removes the entire Virtual Connect domain configuration
and resets it back to the original defaults. After the domain has been deleted,
you are logged out and the Virtual Connect Manager resets.
Syntax delete domain [-quiet]
Examples:
->delete domain
Deletes the Virtual Connect domain configuration and prompts for user
confirmation
->delete domain -quiet
Deletes the Virtual Connect domain quietly without prompting for user
confirmation (primarily used in automated scripting scenarios)
Item Description
set domain Modify domain configuration properties
Syntax set domain [Name=<NewName>] [DomainIp=<Enabled|Disabled>]
[IpAddress=<IPAddress>] [SubnetMask=<mask>]
[Gateway=<Gateway>] [MacType=<VC-Defined|Factory-Default|
User-Defined>] [MacPool=<1-64>] [MacStart=<address>]
[MacEnd=<address>] [WwnType=< VC-Defined|Factory-Default>]
[WwnPool=<1-64>]
Properties:
Name The new name of the domain. Valid characters include alphanumeric, "_", and
".". The maximum length of the name is 64 characters.
DomainIP Enables or disables the Virtual Connect domain IP address. If enabled, then a
valid IP address subnet mask must be configured. If disabled, then DHCP is used
to obtain a valid IP address.
Enabling domain IP address configuration, or changing the domain IP address
can cause a temporary loss of connectivity to the Virtual Connect Manager. Use
caution when changing these settings.
IpAddress
A valid IP address to use for the domain IP address configuration
SubnetMask A valid subnet mask for the domain IP address configuration
Gateway A valid gateway address for the domain IP address configuration
MacType The type of MAC address source to use for assignment. Valid values include VC-
Defined, Factory-Default, and User-Defined
MacPool
The pre-defined MAC pool to use for address assignment. Valid values include
integers 1-64. This property is only valid if the MacType is set to "VC-Defined". If
not specified, the default pool ID is 1.
MacStart The starting MAC address in a custom user-defined range. This property is only
valid if the MacType is set to "User-Defined".
MacEnd
The ending MAC address in a custom user-defined range. This property is only
valid if the MacType is set to "User-Defined".
WwnType The type of WWN address source to use for assignment. Valid values include
VC-Defined and Factory-Default.