HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem - Manual (Page 23)

Command line 23
network
Manage Virtual Connect Ethernet networks.
Supported actions:
add, help, remove, set, show
Item Description
add network Create a new Ethernet Network. After the network has been created, uplink ports
can be added, if the network is not using a shared uplink port set.
Syntax add network <NetworkName> [UplinkSet=<UplinkSetName>
VLanID=<VLanID>] [State=<Enabled|Disabled>]
[SmartLink=<Enabled|Disabled>]
Parameters:
NetworkName The unique name of the new network to create (required)
Properties:
UplinkSet The name of an existing shared uplink port set to use with this new network
(optional). If this property is specified, then a valid VLAN ID must also be provided.
VLanID The VLAN ID associated with the network (used with shared uplink port set only). The
VLAN ID is a valid number between 1 and 4094.
State
Enables or Disables the network. Valid values are "Enabled" and "Disabled". The
default value is "Enabled".
SmartLink Enables or Disables the SmartLink capability for a port. Valid values are "Enabled"
and "Disabled". The default value is "Disabled".
Examples:
->add network MyNewNetwork
Creates a new network, and then adds it to the domain
->add network MyNewNetwork2 UplinkSet=MyUplinkSet VLanID=145
Creates a new network and uses a shared uplink port set
->add network Network1 State=Disabled SmartLink=Enabled
Creates a new network with SmartLink Enabled and Status Disabled
Item Description
remove network
Remove a network from the domain
Syntax remove network <NetworkName | *>
Parameters:
NetworkName The name of an existing network in the domain
Examples:
->remove network MyNetwork
Removes a network
->remove network *
Removes all networks
Item Description
set network Modify an existing Ethernet network
Syntax set network <NetworkName> [Name=<NewName>]
[State=<Enabled|Disabled>] [SmartLink=<Enabled|Disabled>]