HP XP Auto LUN Software - Manual (Page 42)

42 Auto LUN XP for the XP12000/XP10000
Migration was stopped (other reason):
Migration Stopped (CU:LDEV->CU:LDEV) yyyy/mm/dd hh:min:sec (XXXXXXXXXXXX)
(a) (b) (c) (d)
(a) Source volume
(b) Target volume
(c) Canceled time
(d) Reason for cancellation:
•
No reserve volume. No reserved volume is set. Please make another plan.
•
Reserve volume emulation is different. The reserved volume's emulation type is
different.
•
Utilization check. The usage rate is over the limit, or there is no monitor data.
•
Migration failed. Error code: XXXX. The migration operation failed.
•
Reserve volume size is different. Reserve volume size is different.
•
Reserve volume emulation is not supported. The emulation type of reserved volume is
not supported.
•
Utilization check failed. The check of the usage rate finished abnormally.
•
Reserve volume check failed. The check of the reserved volume finished abnormally.
Migration plan was deleted (because the previous plan had been deleted):
Migration Plan deleted (CU:LDEV->CU:LDEV) yyyy/mm/dd hh:min:sec (Pre-Plan is deleted)
(a) (b) (c)
(a) Source volume
(b) Target volume
(c) Canceled time
Started making an auto migration plan:
yyyy/mm/dd hh:min : MakePlan function starts
(a)
(a) Start time
Finished making an auto migration plan:
yyyy/mm/dd hh:min : MakePlan function finishes
(a)
(a) End time
Output the auto migration plans:
X plans are output
(a)
(a) Number of plans
Contents of auto migration plan:
PlanXXX: Src LDEV CU:LDEV in Grp X-X, Dst LDEV CU:LDEV in Grp X-X
(a) (b) (c) (d) (e)
(a) Plan number
(b) Source volume
(c) Parity group of the source volume
(d) Target volume
(e) Parity group of the target volume