HP dvd1260i DVD Writer - Manual (Page 10)

10
ENGLISH
Changing the Jumper
The Master/Slave jumper can be used to set the DVD writer to Master (MA) or Slave (SL)
setting, as shown below. Do not use two jumpers to set MA and SL simultaneously.
M
A
S
L C
S
Master Device
M
A
S
L C
S
Slave Device
(Default setting)
Figure: Setting the Master/Slave jumper.
Cable Select (CS): If you choose the CS setting, the Master/Slave setting will be handled
automatically, according to your hardware configuration. This setting requires a Cable Select
cable. If in doubt about which setting to use, use one of the configurations recommended
below.
IDE Drive Configurations
The following instructions show how to set the Master/Slave jumper according to your
computer and hard disk drive’s current configuration.
Configuration (A)
Current configuration:
Hard disk connected as Master device on the primary IDE port; nothing connected to the
Secondary IDE port.
Setting instructions:
Set the DVD writer’s jumper to Master and connect the DVD writer to the secondary
IDE port.