Document Outline

• HP R/T3000 G2 UPS User Guide
• Abstract
• Notice
• Contents
• Component identification
  • UPS R/T3000 G2 overview
  • UPS front panel
  • UPS front panel controls
  • UPS front panel LED indicators
  • HP UPS R/T3000 models
  • R/T3000 NA and R/T3000j JPN rear panel
  • R/T3000h NA and R/T3000h JPN rear panel
  • R/T3000 INT rear panel
  • REPO port
  • ERM rear panel
• Installation
  • Precautions
  • Preparing to install the hardware
    • Tools and materials
    • Selecting a site
    • Readying the equipment
  • Installing the mounting rails
  • Installing the UPS in a rack
    • Connecting the battery leads
    • Attaching the UPS front bezel
    • Connecting the host computer
      • Connecting the serial communications port
      • Connecting the USB communications port
    • Connecting the REPO port
    • Connecting the ground bonding cable
    • Connecting the UPS to utility power
    • Connecting devices to the UPS
    • Connecting the UPS cord retention clips
    • Charging the UPS batteries
    • Starting power to the load
  • Installing the ERM in a rack
    • Connecting the battery leads
    • Attaching the ERM front bezel
    • Connecting the ERM to the UPS
    • Switching on the ERM circuit breaker
    • Charging the ERM batteries
  • Installing the optional UPS Network Module
    • Connecting the UPS Network Module
  • Installing the UPS as a tower
    • Connecting the battery leads
    • Rotating the logo badge
    • Attaching the UPS front bezel
    • Attaching the tower conversion stands
    • Continuing the installation
  • Installing the ERM as a tower
    • Rotating the logo badge
    • Attaching the ERM front bezel
    • Attaching the tower conversion stands
    • Continuing the ERM installation
  • Installing the extension bars (if included)
  • Connecting and securing the power cords
• UPS operations
  • Modes of operation
    • Standby mode
    • Operate mode
    • Configure mode
    • Battery mode
    • Auto-Bypass mode
  • Operating the UPS front panel controls
  • Configuring the UPS
  • Initiating a self-test
  • Silencing an audible alarm
  • Verifying the REPO port connection
  • Powering down the UPS
• Maintenance
  • Removing the UPS front bezel
  • Removing the ERM front bezel
  • Replacing the batteries
    • Important battery safety information
    • Battery care and storage guidelines
    • Determining when to replace batteries
    • Obtaining new batteries
    • UPS battery replacement procedure
    • Testing the new battery module
  • Replacing the UPS
  • Replacing the ERM
  • Replacing the UPS option card
  • Updating the UPS firmware
    • Configuring a USB to serial converter
    • Reassigning the USB COM ports
• Power management
  • Power Protector software
• Troubleshooting
  • LED troubleshooting
  • UPS is in Auto-Bypass mode
  • UPS is in Converter Off mode
  • General alarm condition
  • Bypass is out of range
  • Battery condition
  • UPS is on battery
  • Input voltage is out of range
  • Overtemperature condition
  • Internal UPS fault condition
  • REPO condition
  • Site wiring condition
  • Overload condition
  • Checksum failure error
  • UPS does not start
  • Low battery shutdowns
  • UPS does not provide the expected backup time
  • UPS frequently switches between utility and battery power
• Specifications
  • UPS physical specifications
  • ERM physical specifications
  • UPS input specifications
  • UPS output specifications
    • Power protection specifications
    • Output tolerance specifications
    • Output feature specifications
  • Battery specifications
  • High-voltage UPS battery runtimes
  • Low-voltage UPS battery runtimes
  • Environmental specifications
  • REPO port specifications
• Spares
  • Ordering spares
  • UPS spare parts list
  • ERM spare parts list
  • Hardware options
• Support and other resources
  • Before you contact HP
  • HP contact information
• Warranty information
  • Limited warranty
  • $250,000 Computer Load Protection Guarantee
  • Pre-Failure Battery Warranty
  • Recommended duration of use
• Regulatory compliance notices
  • Regulatory compliance identification numbers
  • Federal Communications Commission notice
    • FCC rating label
    • FCC Notice, Class A Equipment
    • FCC Notice, Class B Equipment
  • Declaration of conformity for products marked with the FCC logo, United States only
  • Modifications
  • Cables
  • Canadian notice (Avis Canadien)
  • European Union regulatory notice
  • Disposal of waste equipment by users in private households in the European Union
  • Japanese notice
  • BSMI notice
  • Korean notice
  • Chinese notice
  • Battery replacement notice
  • Taiwan battery recycling notice
  • Power cord statement for Japan
• Electrostatic discharge
  • Preventing electrostatic discharge
  • Grounding methods to prevent electrostatic discharge
• Acronyms and abbreviations
• Documentation feedback
• Index