HP ProLiant ML350e Gen8 v2-Server - Manual (Page 29)

Operations 29
3. Install the access panel (on page 26 ).
4. Return the server to an upright position.
5. Lock the front bezel (on page 24 ).
6. Power up the server (on page 23 ).
Remove the full-length expansion board
1. Power down the server (on page 23 ).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Unlock the front bezel (on page 24 ).
4. Place the server on its side.
5. Remove the access panel (on page 25 ).
6. If installed, remove the PCI air baffle (on page 27 ).
7. Open the PCI slot cover retaining bracket.
8. Open the full-length expansion board retaining bracket and remove the expansion board.
IMPORTANT: If removing an expansion board from PCI slot 2, release the retainer latch on the
system board, and then remove the expansion board from the system.