HP 14-in-1 USB2.3 3.5 Media Card Reader - Manual (Page 12)

Connecting the Media Card Reader (USB 2.0 Only)
The Media Reader includes a USB 3.0 to 2.0 adapter for use with computers using USB 2.0
technology.
Connect the USB cable from the media card reader to the USB adapter (1) and then connect the
adapter to the USB 2.0 connector on the system board (2).
CAUTION: Some system boards do not have an available USB connector. If you unplug the USB
cable that is connected to the system board to free up a connector for the HP Media Card Reader,
the front USB ports on the computer will not function.
Figure 2-5 Installing the USB 2.0/3.0 Adapter
Reassembling the Computer
After installing the HP Media Card Reader:
1. Replace the front bezel.
2. Replace the computer cover or access panel.
3. Plug in and power on the computer.
The HP Media Card Reader should now be ready for use. If you encounter problems, refer to
Appendix A,
Solving Common Problems on page 8 .
6 Chapter 2 Installing the Media Card Reader